Can anti-slip sheets be installed over existing flooring?

Often yes, if the surface is sound, clean, dry and suitable for the selected adhesive or mechanical fixing method.

Are anti-slip strips enough for a whole walkway?

Strips may be suitable for local hazard marking or targeted grip, while sheets or covers may be better where continuous coverage is needed.

How-to guide

How to Install Anti-Slip Sheets and Strips

Anti-slip sheets and strips work best when the substrate is clean, dry, stable and properly set out. The installation route should reflect traffic, exposure, drainage and whether the surface needs full coverage or hazard marking.

How-to hub Anti-slip product guide Adhesives and sealants

Installation sequence

Survey the route and mark hazards, turns, thresholds and drainage falls.
Remove loose material, grease, standing water and incompatible coatings.
Dry-fit sheets or strips before adhesive or fixings are applied.
Keep expansion, trip and drainage points clear.
Use adhesive, mechanical fixings or both where the substrate and duty require it.
Inspect all edges before opening the route to foot traffic.

Video slot: installing GRP anti-slip sheets and walkway strips

Coverage calculator

Area length in mmArea width in mmSheet or strip length in mmSheet or strip width in mm

Enter coverage details.

The calculator estimates area coverage only. It does not calculate adhesive consumption, fixing quantity, waste, edge trims or surface repair work.

Where this guidance fits

Use sheets where broad coverage is needed, strips where local grip or hazard marking is enough, and stair covers or nosings for step edges. Ask for support if the route is public-facing, wet, oily, sloped or used by trolleys.

Slip resistance guidance Request support

After fitting guidance

Connect sheet and strip installation with products, sizing and anti-slip support.

Use these routes when an installation needs product selection, prepared sizes or a technical review before work starts.

Anti-slip sheetsReturn to the product page for broad overlay options.Anti-slip stripsReview strip options for targeted routes and step edges.Cut-to-size supportSend dimensions, quantities and marked-up drawings.Product guideCompare sheets, strips, covers, nosings and rung options.Anti-slip guidanceReview slip-risk, substrate and maintenance factors.Technical supportAsk for help with fixing, exposure or substrate constraints.

Expanded practical guidance

Prepare the substrate before installing anti-slip sheets or strips

The quality of an anti-slip installation depends on the surface below it. Survey contamination, moisture, damage, falls and thresholds before measuring, dry fitting and choosing the fixing arrangement.

Prepare the surface

Remove loose material and contamination using a method compatible with the substrate. Repair defects and allow the surface to reach the condition required by the adhesive.

Plan the layout

Dry fit sheets or strips, maintain drainage, avoid raised trip edges and plan joints, thresholds, corners and access to existing covers or equipment.

Bond and fix

Use compatible adhesive and suitable mechanical fixings in accordance with the product route. Control squeeze-out, swarf and movement during cure.

Information to confirm

Substrate type and condition
Coverage, joints, drainage and thresholds
Adhesive compatibility and fixing pattern
Cure, edge and final slip-risk inspection

Practical questions

Can anti-slip sheets cover a damaged floor?

They should not conceal an unstable or unsuitable substrate. Repair and prepare the base so the new surface can be securely supported and fixed.

Should drainage gaps be retained?

Yes where drainage is part of the route. The layout should avoid trapping water or contamination and must not create unsupported edges.

Anti-slip sheets and strips Coverage calculator Anti-slip guidance